The Supply, Delivery and Installation of a Flat Strip Draw Tester (sdt)

Tender description

The National Manufacturing Institute of Scotland (NMIS) seeks a suitably qualified supplier to supply, deliver, install and commission a Flat Strip Draw Tester (SDT) for the purpose of investigating the tribology of sheet metal forming (SMF) processes. At present NMIS are willing to consider a range of designs to meet the specification ( for example, designs may take the form of double die and single die configurations). Given the above, NMIS requires the offered SDT solution to be equipped with the capabilities to simulate these. The capabilities of the offered solution shall include but not be limited to: Draw speeds within the range ≤ 10 and > 100 mm s-1 (preferably ≥ 200 mm s-1) Nominal contact pressures within the range ≤ 5 and ≥ 30 MPa Integrated specimen heating capabilities capable of ≥ 950 °C It is desirable that specimen heating capabilities enable controllable heating rates, with a minimum of ≤14 °C s-1 Integrated method by which to measure the pre-draw specimen temperature Integrated tool heating capabilities capable of ≥ 100 °C Integrated tool cooling system to simulate e.g. operations that involve die quenching Tools should be conducive to in-house manufacture and from a range of materials i.e. plug-and-play friendly. Lot 1: Potential tenderers who believe they can fulfill the above noted requirement are asked to note their interest against this notice by 12:00 noon 6th July 2022.