ITT for the Install of the Chemical Cleaning System

Tender description

Currently the site is using a mixture of chemical and pressure jetters as part of the hygiene washdown system. To comply with customer requirements we are installing a dedicated chemical cleaning system which consists of:-  Centralised pressure pumps  Localised wash down stations (Chemical and Water). The specification is to install a 54mm ring main from the boiler room around the production facility in the attic voids, with drops to each hygiene station and water outlets. The ring main is to be insulated with Armaflex 9mm lagging on completion. A new 25mm compressed air line ring will also be run adjacent to the hot water pipe with 8mm connections to each hygiene station. The hygiene stations and pump booster set will be free issue. The airline will be run too & from the same point as the hot water supply (in the plant room area). As the water pressure in the new hygiene station ring main is higher than the site pressure, a new hot water buffer vessel, plate heat exchanger, 1000 litre buffer vessel & primary pump will be required. This ITT should be read in conjunction with the relevant UK Standards:- The facility is approximately 6750m2 in size. It is estimated that the ring main would be approximately 350m in size but is the responsibility of the supplier / installer to verify. The design document should be presented in the format that will allow Capestone to release in a further Invitation to Tender (ITT) for the procurement and install of the equipment. Format of provided documentation shall be as follows:- Pdf and MS Word for the Design documentation AutoCAD (or equivalent) and pdf for drawings.